Product Information for Bruce Fresh Finish Low Gloss

Bruce Fresh Finish Low Gloss
Maintenance \ Hardwood Floor Care Products\Bruce Fresh Finish Low Gloss

Installation

	Use:	Residential
		Use For Bruce Pre-finished Urethane Hardwood Floors

Description

Type:	Low Gloss Urethane Top Coat
Spread Rate:	Approximately 500 sq. ft. per quart (46.45 m²) 6 containers (plastic) per carton
Advantages:	Easy clean-up with water Milky white color in bottle - dries clear Drying Time: 1-3 hours Freeze-Thaw stable: Yes, completely thaw before use.
Shelf Life:	1 year (from date of manufacture) if not opened Freeze/thaw stable. If frozen, allow to thaw at room temperature before using. Do not store above 120°F (49°C).
Available Units:	32 oz. Item Numbers: W177 (English/Spanish); W117 (English/French
VOC:	300 g/L, excluding water and exempt solvents (2.5 pounds per gallon)

Bruce Fresh Finish Low Gloss is a quick and easy way to bring new life to your Bruce pre-finished urethane hardwood floor. Simply clean,

apply and let dry for a lasting, freshly finished look.

Directions:

Bruce Fresh Finish Low Gloss should be used only on pre-finished urethane hardwood floors. It is NOT intended for use on hardwood floors that have been waxed with paste wax or acrylic waxes or maintained with oils or oil based products.

Preparation

Sweep, dust mop or vacuum the entire floor.
Clean the floor with Bruce Hardwood & Laminate Cleaner. Spray cleaner directly onto floor or onto mop cover.
Clean one 4' x 4' area at a time by using a back and forth motion with the Armstrong mop. Finish one area before moving to the next. Do not allow puddles of cleaner to remain on floor.
Turn the terry cloth cover over to a fresh surface as it becomes soiled or replace with a new mop cover.
Floor must be thoroughly dry before applying Fresh Finish Low Gloss.

Application

To obtain consistent appearance, the entire floor should be coated.

Rock Bruce Fresh Finish Low Gloss container back and forth several times to thoroughly re-mix contents before opening.
Pour Bruce Fresh Finish Low Gloss into a clean flat pan, such as a paint roller tray.
Apply with a new, clean, dampened sponge mop or paint pad. The applicator, even if new, should be thoroughly rinsed before use as contamination may affect results.
Dip the applicator into the flat pan and gently remove excess liquid to minimize applying too much product onto the floor. Spread a thin layer with the applicator in long even strokes in the direction of the wood grain. We recommend applying Bruce Fresh Finish Low Gloss in small areas, 3-4 floor boards wide, moving down the length of the floor. Repeat this pattern until the entire floor has been coated.
Avoid applying heavy coats of Bruce Fresh Finish Low Gloss. Instead, apply two thin coats if necessary. Be sure to allow proper dry time between coats.
Allow to dry for one hour (longer in humid areas) before applying additional coats. Light traffic is permitted within 2-3 hours. Wait 24 hours before heavy traffic or furniture replacement.
Destroy excess materials; do not return to container or retain product for future use.

Do not use Bruce Fresh Finish Low Gloss more than 3-4 times per year to avoid build-up. Do not clean with chemical cleaners for 2 weeks following application.

NOTE

: Do not reuse container. Dispose of container and content's residue in accordance with federal, state and local waste disposal.

Products