![](https://www.floorexpert.com/wp-content/uploads/2024/06/AHF-Family-of-Brands-Logo-6-24-1024x169.png)
Used to fill the gap between two floors of unequal height, or to transition to carpet.
Product Features
- Used to cover the gap between the floor and the wall.
- Surface material: Wear resistant laminate
- Core material: Moisture resistant MDF
Materials and Tools:
- T-mold (includes track and screws)
- Pencil
- Tape measure
- Saw
- Drill and drill bit
- Screwdriver
Installation Procedures
Fasten the Multi-Purpose Reducer to the subfloor. Do NOT fasten it to the floorcovering.
Step 1: Install the flooring leaving a 1-1/8” gap between the two floors for the reducer installation.
![](https://hardwoodexpert.ahfproducts.com/wp-content/uploads/2022/04/image-31.png)
Step 2: Measure and trim to fit.
![](https://hardwoodexpert.ahfproducts.com/wp-content/uploads/2022/04/image-32.png)
Step 3: Center the track between the flooring with 1/4” spacing between the track and floor plank and screw to the subfloor using included screws.
![](https://hardwoodexpert.ahfproducts.com/wp-content/uploads/2022/04/image-33.png)
Step 4: Starting at one end, press the molding into the track inching along the length of the molding. It will NOT snap in all at once. You may also use a rubber mallet.
![](https://hardwoodexpert.ahfproducts.com/wp-content/uploads/2022/04/image-34.png)
Product Dimensions
Length: 94″ (238.76 cm)
For 8 mm floors |
![]() |
For 10 mm and 12 mm floors |
![]() |
![](https://hardwoodexpert.ahfproducts.com/wp-content/uploads/2022/04/image-19.png)