SDS
S-390 Shinekeeper High Gloss Floor Finish SDS
Do not reuse container. Dispose of container and residue in accordance with federal, state and local waste disposal regulations. Do not flush Satinkeeper residue down drains.
Product Information
Traffic Type: Residential, Light Commercial
Use For: Armstrong Flooring Residential Vinyl Sheet and Vinyl Tile, Genuine Linoleum, Asphalt Tile, Rubber Tile, Ceramic – although not much value on glazed ceramic; unglazed – other products designed for this use will produce better results, Slate and Terrazzo – other products designed for this use will produce better results
Do Not Use For: Hardwood, Laminate, Cork or Marble Floors
Spread Rate: 375 – 500 sq ft per quart
Available Units: 1/2 Gallon
VOC Content: <1%; California General Consumer Products Rule, California Code of Regulations
Shelf Life: Two years if not opened.
Storage: Keep from freezing.
Manufacturing Location: USA
| Language | English/Spanish |
| Size | 1/2 Gallon (1.9L) |
| Item No. | 00390806 00390106 (Disc 11/23) |
| Item UPC | 042369002028 |
| Dimensions | N/A |
| Weight | 38 lbs/ctn (17.3kg/ctn) |
| Quantity per Carton | 8 |
Product Features
- S-390 Shinekeeper is sold at 84 Lumber, Lowes, Menards, Sherwin-Williams, and TrueValue
- Ideal for restoring gloss after using Armstrong Flooring New Beginning Resilient Deep Cleaning Stripper
- Renews worn or dulled floors
- Keeps its shine even after repeated cleanings
- Protects floor from scuffs, scratches and dirt
- Does not require buffing
- Resists harsh detergents
- Metal cross-linked acrylic copolymer
- Resists scuffing and water-spotting
- pH of 8.6
- 18% solids
Application Instructions
FLOOR PREP:
- Sweep or vacuum thoroughly
- Wash with Armstrong Flooring Once ‘n Done Floor Cleaner (Do not use Once ‘n Done on linoleum)
APPLYING POLISH:
- Initially, apply two thin coats with a clean damp sponge mop or microfiber applicator mop and allow at least 30 minutes drying time between coats
- Make sure the entire surface is coated
- Dries in approximately 30 minutes – no buffing necessary
- In high humidity areas, Shinekeeper may take longer than 30 minutes to dry
ONGOING POLISHING:
- Reapply Shinekeeper Floor Finish as needed – 1 or 2 coats at a time
- If necessary, remove Shinekeeper with Armstrong Flooring New Beginning Floor Stripper & Cleaner. Note: Armstrong Flooring New Beginning Floor Stripper & Cleaner can not be used on linoleum to remove the Shinekeeper. Use a linoleum-safe stripper instead.
NOTE:
- In high humidity areas, Satinkeeper may take longer than 30 minutes to dry