Precautions
Caution Eye and Skin Irritant
SDS
For Use With
For use with the following Installation Systems:
Product Information
| Type | Water-based/resin; pressure-sensitive; acrylic base |
| Color | White |
| Taggants | Contains no visible taggants |
| Applicator | Brush or roller |
| Coverage | 200–250 sq. ft./ half-gallon (18-23 sq. m.) |
| Units | Half-gallon (1.89 L) |
| Open Time | Dry to pressure sensitive state; minimum of 20-30 minutes |
| Working Time | Unlimited (working times may vary based on job conditions, temperature, humidity, air circulation, etc.) |
| Shelf Life | 1 year, unopened |
| Freeze/Thaw Stable | No, keep from freezing |
| VOC Content | 2 g/L; calculated and reported, SCAQMD 1168 |
| Clean Up | Wet–clean, white cloth with neutral detergent and water Dry– clean, white cloth and mineral spirits |
| Walls | Standard, structurally sound |
| Advantages | Moisture and alkali resistant Excellent grab AGIS Guarantee Nonflammable, ammonia-free and low odor Contains low or no organic solvents |
| Language | English/Spanish | English/French |
| Size | 1/2 Gallon | 1/2 Gallon (1.9L) |
| Item No. | 00580406 | S-580406 |
| Item/Carton UPC | 0-42369-93488-6 | 042369935043 |
| Carton Weight | 19.8 lbs | 19.8 lbs |
| Items per Carton | 4 | 4 |
| Cartons per Pallet | 54 | 54 |
Warranty
When S-580 is used with a recommended Armstrong floor application, the Armstrong Guaranteed Installation System warranty applies.
Sustainability
LEED Credits: EQ 4.1
Sustainable Design Information
LEED Credit Information – Installation Products
Recommended Substrates
Will bond to all substrates listed below but refer to flooring installation system for specific installation recommendations:
- Concrete and concrete block
- Gypsum drywall
- Plaster
- Wood and plywood
- Brick
- Abraded plastic laminate
DO NOT USE OVER: Concrete with excessive moisture and/or alkali; substrates treated with fire-retardant chemicals, fungicides, preservatives, release agents, adhesive removers, sealers, curing compounds or other incompatible treatmentsStir well before using
Application Instructions
- Condition the area to be installed, adhesive, and flooring to 65 degrees F (18 degrees C) or above for 48 hours before, during, and for 48 hours after installation.
- Substrate must be smooth, sound, dry, clean, and free of dirt, wax, polish, paint, and all other foreign matter which may interfere in a good bond, including curing agents and sealers.
- Glossy surfaces must be abraded for a proper bond.
- Stir any liquid on the surface into the adhesive.
- Apply two coats of S-580 Flash Cove Adhesive with a brush 4″ on the floor as well as up the entire cove area. Allow adhesive to dry to a pressure-sensitive state between applications.
- Before installing flooring, allow adhesive to set open for 20-30 minutes until it becomes dry to pressure sensitive state.
- After appropriate open time, install floor. Working time is unlimited to cut, fit and reposition.
- Roll adhered areas with a hand roller and seam seams as recommended.
- Remove wet adhesive residue using a clean, white cloth dampened with soapy water. Use mineral spirits for dried adhesive residue carefully following warnings on container.
Product Image
