Product Features

Covers the expansion space between two equal height flooring surfaces.
Used at doorways and transitions to another surface of approximate the same height to allow for expansion space. Also may be referred to as a “saddle” molding.

Installation Procedures

1. DO NOT nail or drill into the molding. This will compromise the water resistant wear layer.
2. For best results, use an MS polymer adhesive. Cut the tip of the cartridge to create a 1/4″ opening at 45 degrees.
3. Applying the adhesive to the profile bottom allows for best control. Applying the adhesive directly to the subfloor is also acceptable.
4. Firmly press the profile against the subfloor, occasionally lifting the piece to ensure proper transfer is made to the bonding surface.
5. DO NOT nail or drill into the molding. This will compromise the water resistant wear layer.
6. For best results, use an MS polymer adhesive. Cut the tip of the cartridge to create a 1/4″ opening at 45 degrees.
7. Applying the adhesive to the profile bottom allows for best control. Applying the adhesive directly to the subfloor is also acceptable.
8. Firmly press the profile against the subfloor, occasionally lifting the piece to ensure proper transfer is made to the bonding surface.
9. Avoid traffic on the area until the adhesive has cured.

Product Structure

Product Images

T-Mold (Profile #299)

---

T-Mold (Profile #289)